An independent Franco-Benelux publication 
An independent international publication 
The paste obtained in this way must be left for a few minutes before it is applied with the correct, smooth, stainless steel spatula. Before you apply the paste, always check the moisture in the covering floor – this must be under 2% (under 0.5% with anhydrite). The surrounding temperature should be between 15 and 25°C, whilst the relative air humidity must not exceed 75%. If the substrate is loose, it is better to pre-treat it with Pavilast K. To obtain a better spreading quality, you can add ADECON K500 to Pavilast R. Adesiv recommends that you use Adesiv products for glueing.
Adesiv
Adesiv promotes the cement-based levelling compound Pavilast R for levelling uneven floors. This is done in accordance with the following fitting instructions. Always check the moisture in the bottom layer using the right instruments. The bottom layer must not contain any liquid and must be free of loose items such as plaster, dust, oils, or wax.
Pour the powder (25kg) and the water (6.5kg), which has reached room temperature, into a clean bucket and mix the compound with an electric stirrer until you get an even paste with no lumps and of a thickness which you can spread.
Additional Info
- Telefoonnummer: +39 (0) 0424566406
- Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
- Website: w
